Installation and precautions of track connecting rod oil seal Wear ring for excavator,For excavator track,For excavator accessories Safe Seal Technology Co., Ltd. , https://www.jolseals.com
Outdoor gates are used in the harsh environment of the open air. Their bad performance is mainly reflected in the rain and wind and sun exposure. The former can easily cause the damper to affect the service life of the gate, and the latter can form a strong interference signal, resulting in smart gates. Abnormal operation. However, in actual life, some indoor gates will also cause them to use under strong light due to changes in the use environment. At this time, they must start to do their best to protect the smart gates during installation.
In the early stage of installation, the equipment for waterproofing and sun protection of the gate must be well-prepared. The joints at the chassis of the glass-plastic sealing gate should ensure that the equipment is dry, and the water vapor ingress of rainy weather should be prevented; the electronic control part of the gate of the gate machine should be waterproof. Ensure that the intrusion of water vapor has no effect on the swing gate; the infrared radiation of the detection part of the gate adopts anti-glare fire to prevent the sunlight from disturbing the photoelectric switch signal.
According to the site conditions during installation, the outdoor ground installation can be used to raise the original ground level to about 10CM, and to cover the bottom of the tarpaulin and other materials, so as to avoid the smart gate immersed in the water during the storm, you can also Avoid water vapor at the bottom and moisture damage to equipment. In addition, the safety hazards around the gate must be excluded to prevent heavy winds from blowing heavy objects onto the gate.
The so-called safety system is not a trivial matter. Only when the smart gate is installed, do a careful preparation to ensure the safe and stable operation of the equipment.
The installation steps for the track link oil seal are as follows:
1. Cleaning: Clean the connecting parts to ensure that the surface is flat, clean, and free of grease and dirt.
2. Oil application: Apply a layer of lubricating oil to the connecting parts for better installation.
3. Installation: Gently push the oil seal into the connection area to ensure that the lip of the oil seal is not damaged.
4. Positioning: After positioning the oil seal, press it with your fingers to ensure it is in the correct position.
5. Inspection: Check if the oil seal is installed correctly and ensure that the lip is not damaged.
The precautions are as follows:
Before installation, check if the oil seal is damaged. If the oil seal is damaged, replace it with a new one.
Before installation, ensure that the surface of the connecting parts is flat, clean, and free of grease and dirt.
3. When installing the oil seal, gently push in to avoid damaging the lip of the oil seal.
4. After installation, check whether the oil seal is installed correctly to ensure that the lip is not damaged.
5. During use, the condition of the oil seal should be regularly checked. If any damage or wear is found, the oil seal should be replaced in a timely manner.
Waterproof treatment in smart gate installation
In the early morning of August 2, typhoon “Nicole†landed in the Pearl River Delta. Beijing Ximoro’s manufacturers reminded the users of smart gates in this area to pay attention to the waterproofing of the gates, even if the outdoor equipment is used.